Hi guys, I have been inspired by several threads to have a go at wiring up a colour wheel. I got a 6 position rotary switch from the local electronics store for about $2 and then set about the task. First I tested different RGB combinations with varying resistors and drew up a little chart for reference, and then worked out what colours I was going to use for the project. In the end I decided on Yellow, Lime Green, CG, ?EG shade, AB and GB. Essentially moving through the spectrum slowly from the yellow through to the GB. I considered DVA or VA, which could have replaced one of the greens but didn't for this one. I didn't do red as its a sith colour, and so stuck with jedi colours so to speak. Also I considered AS, was included actually until I started drawing up the wiring diagrams, and given I only had a 2 pole switch it made things too messy. Anyway, I have done the MLS plus colour wheel unit, now I just have to make a saber to put it in
![Undecided](http://saberforum.com/Smileys/default/undecided.gif)
This is the MLS colour wheel combo, the rotary switch is quite long but is plastic and can be trimmed to size and an appropriate knob put on
![](http://i1150.photobucket.com/albums/o619/messop/image-13.jpg)
Yellow
![](http://i1150.photobucket.com/albums/o619/messop/image-9.jpg)
Lime Green
![](http://i1150.photobucket.com/albums/o619/messop/image-15.jpg)
Consular Green
![](http://i1150.photobucket.com/albums/o619/messop/image-10.jpg)
?Emerald Green
![](http://i1150.photobucket.com/albums/o619/messop/image-12.jpg)
Arctic Blue
![](http://i1150.photobucket.com/albums/o619/messop/image-11.jpg)
Guardian Blue
![](http://i1150.photobucket.com/albums/o619/messop/image-14.jpg)