Click here for lightsabers
  • Home
  • Help
  • Login
  • Register
Pages: [1]   Go Down
Author Topic: Customization Question  (Read 813 times)
VFrost0
Force Sensitive
*

Force Alignment: 0
Posts: 5
« on: May 17, 2014, 01:29:36 AM »
I've gotten the replacement switch so I can change a couple of my sabers lighted switches. The one thing I have not found yet, is what to use to reach and unscrew the nut on the switch.

So, I'm asking the masters, what do you use to reach 8 inches into a 1 in tube and manipulate a screw around a series of wires.

Once I get that far, I begin working on the next step of disassembling the Electronics in the other one.

_Strix
Logged
Strix

Darth Vapour
Knight Major
*

Force Alignment: -98
Posts: 356
« Reply #1 on: May 17, 2014, 10:13:18 AM »
A flat head screw driver should do the trick. Slow going though. The nut is hexagonal so you can push at the corner of a flat surface to get it rotating. If you are removing a standard guarded switch there is no nut and it's just a matter of levering it up.
Logged
"WRATH" Overlord PO Obsidian
"ICE" Customized Liberator AB Obsidian
"Fire" Dark Liberator BR
Hasbro Vader FX
Aeon V2 SY, Consular CG,
"Guardian" Customised SI V2 GB
Custom built Shock CG with obsidian FO FOC
Custom Yari staff BR

Pages: [1]   Go Up
Send this topic | Print
Jump to: